01 passive fire protection

Fire Door Inspections

Fire doors are only effective if every component — leaf, frame, seals, hinges, glazing and hardware — is correctly specified, fitted and maintained. A damaged seal, a wedged-open door or the wrong hinges can be enough to compromise an entire escape route.

Our inspectors carry out a methodical, door-by-door survey of your premises, checking each fire door against current guidance and recording its condition with photographs and a clear risk rating.

What's included

  • Door leaf, frame and gap tolerance checks
  • Intumescent and cold smoke seal condition
  • Hinges, closers, and self-closing performance
  • Glazing, vision panels and door furniture
  • Signage and door status (e.g. fire door keep shut/locked)
  • Full door schedule with photographic evidence and priority actions
BS 8214 guidance BS 476 / BS EN 1634 referenced Regulatory Reform (Fire Safety) Order
02 active fire protection

Fire Extinguisher Inspections

Portable fire extinguishers need to be in the right place, the right type, and in good working order — every time. We check that your extinguisher provision matches the risks on site and that every unit is correctly maintained and serviceable.

Our survey covers presence and positioning, visual condition, pressure gauge readings, tamper seals, and service history, giving you a single, clear picture of your extinguisher estate.

What's included

  • Extinguisher location, type and provision mapping
  • Visual condition, corrosion and damage checks
  • Pressure gauge, pin and tamper-seal verification
  • Service tag and maintenance history audit
  • Signage and accessibility of each unit
  • Site-wide summary report with replacement/service recommendations
BS 5306-3 guidance BS EN 3 extinguisher standards Regulatory Reform (Fire Safety) Order
03 passive fire protection

Fire Stopping Inspections

Compartmentation only works when every wall, floor and service penetration is properly sealed. Cabling, pipework and ductwork installed or altered after a building is handed over are among the most common causes of compromised fire barriers.

We survey walls, floors, risers and voids to identify unsealed penetrations, missing or degraded fire-stopping materials, and other breaches — giving you a prioritised record of what needs attention and where.

What's included

  • Compartment wall and floor penetration surveys
  • Service riser and void inspections
  • Identification of unsealed or poorly sealed penetrations
  • Assessment of fire-stopping materials and fire-rated ductwork/dampers
  • Photographic schedule of defects, mapped by location
  • Risk-prioritised remediation recommendations
Approved Document B BS 9999 / BS 476-20 Regulatory Reform (Fire Safety) Order

Not sure which inspections you need?

Tell us a bit about your site and we'll recommend the right starting point.

Ask Us a Question Book an Inspection